Jm HHC-42 Bedienungsanleitung Seite 1

Pg. 1 O P E R A T O R ’ S M A N U A L Set-Up Instructions and Parts Catalog for Model HHC-32, HHC-38 and HHC-42 Trail-Blazer Header Transports

Pg. 10 SET-UP INSTRUCTIONS (continued) 5. Attaching the Adjustable Brackets and Upper Bar Secure the Upper Bar Channel Support to the left

Pg. 11 SET-UP INSTRUCTIONS (continued) 7. Installing the Light Kit A. Insert the Main Wiring Harness, end opposite the Flat-Four Connector

Pg. 12 SET-UP INSTRUCTIONS (continued) 8. Placing the Amber, Red and Orange Reflective Decals Place the reflective decals as shown below.

Pg. 13 PARTS LIST Main Frame and Upper Bar Front Axle Assembly # Part # Description 1 HHMF2 Header Transport Main Fram

Pg. 14 PARTS LIST Tie-Down Bracket and Adjustable Header Mount Adjustable Upper Bar Mount # Part

Pg. 15 PARTS LIST Rear Axle Assembly Rear Fender Assembly # Part # Description 3 58FW 5/8” Flat Washer 4 58LN 5/8” Lock Nu

Pg. 16 PARTS LIST Light Kit # Part # Description # Part # Description 1L RLT-L Light Assembly (L/H) 17 12114-G5-FB 1/2” x 1 1/

Pg. 17 INITIAL OPERATION / MAINTENANCE BE CERTAIN THAT ALL POWER IS SHUT OFF BEFORE SERVICING THE HEADER TRANSPORT Before the header transport is put

Pg. 18 SERVICE / MAINTENANCE RECORD Date Description Notes

Pg. 2 TO THE DEALER: Read manual instructions and safety rules. Make sure all items on the Dealer’s Pre-Delivery and Delivery Check Lis

Pg. 3 MODEL HHC-32, HHC-38 and HHC-42 Header Transport Specifications DIMENSIONS HHC-32 HHC-38 HHC-42 A 43’-

Pg. 4 GENERAL INFORMATION TO THE OWNER: The purpose of this manual is to assist you in operating and maintaining your running gear in

Pg. 5 GENERAL INFORMATION (continued) BOLT TORQUE CHART Always tighten hardware to these values unless a different torque or tightening procedure is

Pg. 6 TABLE OF CONTENTS INTRODUCTION 2 EXPRESS WARRANTY 2 SPECIFICATIONS 3 GENERAL INFORMATION 4 BOLT TORQUE CHART 5 SAFETY RULES 7 SAFETY 7 S

Pg. 7 SAFETY RULES ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!  Safety is a primary concern in the design and manufacture of our products.

Pg. 8 DW-108 DW-121 SAFETY SIGNS ATTENTION: BECOME ALERT! YOUR SAFETY IS INVOLVED! Replace Immediately If Damaged or Missing! IMPORTANT: Install

Pg. 9 SET-UP INSTRUCTIONS (continued) 3. Mounting the Rear Fenders Place one of the Base Fender Support Rail (left or right) on top of the two re